Assembling The Breast Pump - Philips AVENT SCF398 Handbuch

English
14
Battery indicator light description
All lights are steady First light is steady
on. on.
The battery is fully The battery is
charged. charged sufficiently
for one session.*
* One session is the equivalent of 20 minutes (double electric breast pump) or 30 minutes (single
electric breast pump).

Assembling the breast pump

Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with
milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
Note: Correct placement of the cushion, silicone diaphragm and silicone tube is essential for the
breast pump to form a proper vacuum.
1. Wash your hands
thoroughly with soap
and water.
First light flashes
slowly.
The battery is low,
charging needed.
2. Push the white valve
in the pump body as far
as possible.
First light flashes
quickly.
The battery is very
low, the device will
soon stop
operating.
3. Screw the pump body
onto the bottle.
Battery lights light
up one by one and
go out all together.
The battery is
charging.
4. Place the cushion in
the pump body and
make sure that the rim
covers the pump body.