System Status Troubleshooting; Maintenance - Renogy ROVER Serie Installation

System Status Troubleshooting

PV indicator
Off during daylight
BATT Indicator
White Slow Flashing
White Fast Flashing
Load Indicator
White Fast Flashing
Error Indicator
WhiteSolid
Risk of Electric Shock! Make sure that all power is turned off before touching the
WARNING
terminals on the charge controller.
For best controller performance, it is recommended that these tasks be performed from time to time.
1. Check that controller is mounted in a clean, dry, and ventilated area.
2. Check wiring going into the charge controller and make sure there is no wire damage or wear.
3. Tighten all terminals and inspect any loose, broken, or burnt up connections.
4. Make sure LED readings are consistent. Take necessary corrective action.
5. Check to make sure none of the terminals have any corrosion, insulation damage, high
temperature, or any burnt/discoloration marks.
EN
Ensure that the PV wires are correctly and tightly secured inside the
charge controller PV terminals. Use a multi-meter to make sure the
poles are correctly connected to the charge controller.
Disconnect loads, if any, and let the PV modules charge the battery bank.
Use a multi-meter to frequently check on any change in battery voltage to
see if condition improves. This should ensure a fast charge. Otherwise,
monitor the system and check to see if system improves.
Using a multimeter check the battery voltage and verify it is not
exceeding 32 volts.
The Load circuit on the controller is being shorted or overloaded. Please
ensure the device is properly connected to the controller and make sure it
does not exceed 20A (DC).
System Error. Please check LCD for Error code

Maintenance

Troubleshoot
Troubleshoot
Troubleshoot
Troubleshoot
30