Renogy ROVER Serie Installation Seite 24

Programming Load Terminal
1. If the characters displayed on top of "<Mode>" are "ON", it indicates that the load is switched
on
2. Tap " Right Arrow Button" to enter the load setting mode, and right below the "<Mode>", the
mode characters or digits will begin to flash. Use " Up and Down Arrow Buttons" to select any
one from the load modes listed in the following table and tap " Right Arrow Button" again to
complete the load mode setting.
3. Press and hold " Right Arrow Button " in any menu but not the setting mode: if the current load
mode is "manual mode", pressing and holding the key will switch on/ off the load; if the current
load mode is not "manual mode", pressing and holding the key will cause the display to skip
to the load mode setting interface and a reminder will pop up telling the user in this mode,
pressing and holding the key will not switch on/ off the load.
Load Mode Options
Load Mode
Light+ On
Light+ 01H-14H
Manual
Debug
Normal On
23
Load mode setting icon
LOAD
Mode
Solar Light Control Mode
Time control
Manual Mode
Test
24Hr
Load state
OFF
<Mode>
Manual Load mode
Description
The load will turn on at night when the solar
panel is no longer producing any power after
a short time delay. The load will turn off when
the panel starts producing power.
When the panel is no longer producing
power the load will be ON for 1-14 hours or
until the panel starts producing power.
In this mode, the user can turn the Load
On/Off by pressing the Enter button at any
time.
Used to troubleshoot load terminal (No Time
Delay). When voltage is detected load will be
off and when no voltage is detected load will
be on.
The load will be on for 24 hours a day.
EN