Installation - Renogy ROVER Serie Installation

Recommended tools to have before installation:
Connect battery terminal wires to the charge controller FIRST then connect
WARNING
the solar panel(s) to the charge controller. NEVER connect solar panel to
charge controller before the battery.
Do NOT connect any inverters or battery chargers into the LOAD
WARNING
TERMINAL of the charge controller.
Do not over tighten the screw terminals. This could potentially break the piece that holds the
CAUTION
wire to the charge controller.
Refer to the technical specifications for max wire sizes on the controller and for the maximum
CAUTION
amperage going through wires.
EN

Installation

Screwdriver Multi-Meter
INVERTER
BATTERY
CHARGER
HIGH AMP
DRAWING DEVICE
10