Dip Switch Setting On The Radio Piggy-Back - SMA BEAMPB-NR Handbuch

Installing a Radio Piggy-Back in an Inverter

1.2 DIP Switch Setting on the Radio Piggy-Back

This chapter is intended solely for qualified electricians!
All work on the inverter may only be performed by qualified electricians!
Please follow
documentation!
The Radio Piggy-Backs can be set to groups via the DIP switches (0 to 15, see figures
below). This allows you to exclude other inverters when recording data with the Sunny
Beam, if to many other inverters in the vicinity are set to the same group. The Sunny
Beam and the Radio Piggy-Backs must always be set to a common group. The Piggy-
Backs are set to group 1 by default.
You can change the group for the Radio
Piggy-Back by pushing the white DIP switches
on the Radio Piggy-Back (see figure at right)
up or down. Please refer to the overview to
find out which position of the switches
corresponds to which group. See the Sunny
Beam Documentation on how to change the
group setting for the Sunny Beam.
Overview of Radio Piggy-Back group settings
(factory
setting)
16 BEAMPBNR-BXX072623
all safety
0
1
2
3
4
5
instructions contained
6
7
8
9
10
11
SMA
Technologie AG
in the inverter
DIP switches
12
13
14
15