Installation (B): Antenna, Piggy-Back Ex Factory - SMA BEAMPB-NR Handbuch

SMA
Technologie AG

1.1.3 Installation (B): Antenna, Piggy-Back ex Factory

If the Radio Pigy-Back has already been installed at the factory, the antenna can be
fastened to the inverter as follows.
This chapter is intended solely for qualified electricians!
All work on the inverter may only be performed by qualified electricians!
Please follow
documentation!
1. Remove the protective cap from the thread of the antenna
on the inverter housing.
2. Plug the sealing on the thread of the
antenna on the inverter housing.
3. Screw the antenna tip to the thread of
the antenna on the inverter housing.
all safety instructions
Installing a Radio Piggy-Back in an Inverter
contained in
BEAMPBNR-BXX072623
the inverter
15