Symbols On The Product - SMA SUNNY BOY 3.0 Schnelleinstieg

SMA Solar Technology AG
Damage to the product due to cleaning agents
The use of cleaning agents may cause damage to the product and its components.
• Clean the product and all its components only with a cloth moistened with clear water.
Change to the names and units of grid parameters to comply with the grid-
connection requirements in accordance with Regulation (EU) 2016/631
(valid from April 27, 2019)
To comply with the EU grid-connection requirements (valid from April 27, 2019) the names
and units of grid parameters were changed. This change is valid from firmware version
≥ 3.00.00.R if a country data set for fulfilling the EU grid-connection requirements (valid from
2019-04-27) is set. Names and units of grid parameters for inverters with firmware version
≤ 2.99.99.R are not affected by this change and remain valid. This also applies from firmware
version ≥ 3.00.00.R if a country data set that is valid for countries outside the EU is set.
A country data set must be set for feed-in operation
From firmware version , the activation conditions for feed-in operation were changed.
To ensure the inverter begins feed-in operation during initial commissioning, a country data set
must be set (for instance via the installation assistant on the user interface of the product, or via
a communication product).
If no country data set is set, then feed-in operation will be stopped. This state is signaled by the
green and red LEDs flashing simultaneously.
The inverter will automatically start feed-in operation only after the inverter configuration is
completed.
The country data set must be set correctly.
If you select a country data set which is not valid for your country and purpose, it can cause a
disturbance in the PV system and lead to problems with the grid operator. When selecting the
country data set, you must always observe the locally applicable standards and directives as
well as the properties of the PV system (e.g. PV system size, grid-connection point).
• If you are not sure which standards and directives are valid for your country or purpose,
contact the grid operator.
3

Symbols on the Product

Icon Explanation
Beware of a danger zone
This symbol indicates that the product must be additionally grounded if addi-
tional grounding or equipotential bonding is required at the installation site.
Beware of electrical voltage
The product operates at high voltages.
Quick Reference Guide
NOTICE
3 Symbols on the Product
SBxx-1AV-41-IS-xx-16 9