Product Description - Concept VS5030 Bedienungsanleitung

EN

PRODUCT DESCRIPTION

1. Front wire mesh
2. Nut
3. Fan
4. Mesh attachment nut
5. Rear wire mesh
6. Unit body
7. Upper connecting rod
8. Lower connecting rod
9. Humidifier base
10. Rectangular screw
11. Oscillation switch
12. Power switch
6
7
5
8
9
10
36
1
4
3
2
11
12
ASSEMBLY
ATTENTION!
Pull the power cord out of the socket before assembling or disassembling the unit. The fan may only be used with the
front and rear protective mesh attached (1), (5).
1. Attach the lower and upper connecting rods (8, 7) to the base (10) and tighten with screws.
2. Mount the unit body (6) onto the support stand.
3. Position the rear protective mesh (5) onto the drive unit so that the pins on the unit correspond with the holes in
the mesh. Use the attachment nut (4) to secure the assembly.
4. Slide the fan (3) onto the motor shaft by positioning the grooves in the fan hub against the shaft tongues.
5. Turn the nut (2) counter-clockwise to fasten the fan.
6. Position the front wire mesh so that the mesh edges fit into the grooves on the inside of the ring.
7. Tighten the fastening ring with the screw.
OPERATING INSTRUCTIONS
Prior to using the unit verify the power cord is intact.
1. Place the unit on the floor securely so it cannot tip over.
2. Uncoil the power cord.
3. Tilt the fan as required. You will hear several clicks that lock the fan in individual positions.
4. Connect the power cord plug to the wall socket.
5. Use the mode selector (12)to choose the required speed –
0 – OFF, 1 – LOW, 2 – MEDIUM, 3 – HIGH.
6. Press the oscillation button (11) to switch on the fan oscillation. Press again to turn the oscillation off.
7. After use, turn the mode selector to 0 and unplug the unit from the mains.
VS5030 VS5030
EN
37