Product Description; Cleaning And Maintenance - Concept VS 5020 Bedienungsanleitung

EN
• Never use the unit if the power supply cord or plug is damaged. Have any defects immediately repaired by
an authorized service center.
• Do not use the unit if it does not operate properly, or if it has been dropped, damaged or exposed to liquid.
Take the unit to an authorized service center for testing and repair.
• The unit is not designed for outdoor use.
• The unit is intended for household use only; it is not designed for commercial application.
• Do not touch the unit if your hands are wet.
• Do not immerse the power cord, plug, or unit in water or any other liquid.
• Do not attempt to repair the unit by yourself. Contact an authorized service center for repair.
• This appliance may be used by children 8 years of age and older and by persons with physical or mental
impairments or by inexperienced persons if they are properly supervised or have been informed about
how to use of the product in a safe manner and understand the potential dangers. Children must not play
with the appliance. This appliance may be cleaned by children 8 years of age and older if they are properly
supervised. Keep this appliance and the power cord out of reach of children younger than 8 years of age.
Failure to follow the manufacturer's instructions may lead to refusal of warranty repair.
1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the appliance.

PRODUCT DESCRIPTION

1 Front wire mesh
2 Nut
3
Fan
4
Mesh attachment nut
5
Rear wire mesh
6 Unit body
7 Stand
8 Mode selector
9 Oscillation selector
1 2 3
24
4 5
9
6
8
7
VS 5020 | 5021
ASSEMBLY
AT TENTION!
Pull the power cord out of the socket before assembling or disassembling the unit.
The fan may only be used with the front and rear protective mesh attached (1), (5).
1. Mount the unit body unit onto the support stand.
2. Position the rear protective mesh (5) onto the drive unit so that the pins on the unit correspond with the
holes in the mesh. Use the attachment nut (4) to secure the assembly.
3. Slide the fan (3) onto the motor shaft by positioning the grooves in the fan hub against the shaft
tongues.
4. Turn the nut (2) counter-clockwise to fasten the fan.
5. Position the front wire mesh so that the mesh edges fit into the grooves on the inside of the ring.
6. Tighten the fastening ring with the screw.
OPERATING INSTRUCTIONS
Prior to using the unit verify the power cord is intact.
1. Place the unit on a stable surface or floor to avoid tipping over.
2. Uncoil the power cord.
3. Tilt the fan as required (Fig. 1). You will hear several clicks that lock the fan in individual positions.
4. Connect the power cord plug to the wall socket.
5. Use the mode selector to choose the required speed –
0 – OFF, 1 – LOW, 2 – MEDIUM, 3 – HIGH
0 – OFF, 1 – LOW, 2 – HIGH (VS 5020).
6. To turn fan oscillation off while the unit is running, pull out the oscillation selector (Fig. 2). Pushing the
selector in turns oscillation on.
7. After use, turn the mode selector to 0 and unplug the unit from the mains.
fig. 1 fig. 2

CLEANING AND MAINTENANCE

AT TENTION!
Always disconnect the power cord from the socket before cleaning the unit!
VS 5020 | 5021
EN
25