Important Safety Instructions - Nilfisk-ALTO ATTIX 995-0H/M SD XC Type 22 Kurzanleitung

This document
This document contains the safety information
relevant for the appliance along with a quick
reference guide.
Prior to using the appliance for the
first time, be sure to read this docu-
ment through and keep it ready to
hand.
Further support
Detailed information on the appliance can
be found in the operating instructions,
which you can download from our web site
at www.nilfisk-alto.com.
For further queries, please contact the Nilfisk-
Alto service representative responsible for
your country. See reverse of this document.

Important safety instructions

Symbols used to mark instructions
DANGER
Danger that leads directly to seri-
ous or irreversible injuries, or even
death.
WARNING
Danger that can lead to serious
injuries or even death.
CAUTION
Danger that can lead to minor
injuries and damage.
The appliance must
• only be used by persons, who have been
instructed in its correct usage and explicitly
commissioned with the task of operating it
• only be operated under supervision
• not be used by children
Before starting work, the operating staff must
be informed on
• use of the vacuum cleaner
• risks associated with the material to be
picked up
• safe disposal of the picked up material
OEL = Occupational exposure limit
1)
ATTIX 995-0H/M SD XC Type 22
1. Do not use any unsafe work techniques.
2. Never use the vacuum cleaner without a
filter.
3. Switch off the appliance and disconnect
the mains plug in the following situations:
- Prior to cleaning and servicing
- Prior to replacing components
- Prior to changing over the appliance
- If foam develops or liquid emerges
Besides the operating instructions and the
binding accident prevention regulations valid
in the country of use, observe recognised
regulations for safety and proper use.
Purpose and intended use
Since 1997, there is a new division of
hazardous dusts and their assigned vacuum
machines. These are regulated by IEC 60335-
2-69 (world wide) and by EN 60335-2-69
(European wide).
Dust Class M (medium). The dusts
which belong to this class are: dusts
with OEL values
well as saw dust. The machine is tested in its
entirety by vacuums for this dust class. The
maximum degree of permeability is 0.1% and
the disposal must be low dust.
Dust Class H (high). The dusts which
belong to this class are: dusts with
OEL values , all carcinogenic dusts
1)
and dusts which are mixed with pathogenic
agents. Vacuums for Dust Class H are tested
in their entirety and have a maximum degree
of permeability of 0.005%. The disposal must
be dust free.
These vacuums may be used for
picking up dusts from the Dust
Classes L, M and H as well as ex-
plosive dusts which makes a Series
Type 22 vacuum necessary. Included in these
classes are non-carcinogenic dusts with OEL
values > 0.1 mg/m³ and/or flammable dusts
in Zone 22.
The air flow in safety vacuum systems has to
be strictly controlled to achieve a minimum
flow rate of V = 20 m/s in the suction hose.
min
> 0.1 mg/m³ as
1)
9
GB
D
F
NL
I
N
S
DK
SF
E
P
GR
TR
SLO
HR
SK
CZ
PL
H
RO
BG
RUS
EST
LV
LT
J
CN
ROK
T
MAL