Electrical Connection - Nilfisk-ALTO ATTIX 995-0H/M SD XC Type 22 Kurzanleitung

Storage
1. Store the appliance in a dry place, pro-
tected from frost.

Electrical connection

1. It is recommended that the vacuum
cleaner should be connected via a residual
current circuit breaker.
2. When picking up flammable dust in zone
22, extension lines, couplings and adapt-
ers must not be used.
3. Arrange the electrical parts (sockets, plugs
and couplings) and lay down the exten-
sion lead so that the protection class is
maintained.
4. Connectors and couplings of power sup-
ply cords and extension leads must be
watertight.
Extension lead
1. As an extension lead, only use the version
specified by the manufacturer or one of a
higher quality. See operating instructions.
2. When using an extension lead, check the
minimum cross-sections of the cable:
Cable length
< 16 A
up to 20 m 1.5 mm
20 to 50 m 2.5 mm
Maintenance, cleaning and repair
During the following work, ensure that dust is
not unnecessarily spread around. Wear a P2
breathing mask.
CAUTION: In the case of asbestos abatement
wear additional single-use clothing.
Only carry out maintenance work described in
the operating instructions.
Always pull out the mains plug before clean-
ing and maintenance of the vacuum cleaner.
During maintenance and cleaning, handle the
vacuum cleaner in such a manner that there
is no danger for maintenance staff or other
persons.
In the maintenance area
1. Use filtered compulsory ventilation
2. Wear protective clothing
3. Clean the maintenance are so that no
harmful substances get into the surround-
OEL = Occupational exposure limit
1)
Cross section
< 25 A
2.5 mm
2 2
4.0 mm
2 2
ATTIX 995-0H/M SD XC Type 22
ings.
Before removing the vacuum cleaner from the
area contaminated with harmful substances:
1. Clean the outside of the vacuum cleaner,
wipe it clean or pack the vacuum cleaner
in well sealed packaging
2. and avoid spreading deposited harmful
dust.
During maintenance and repair work all
contaminated parts that could not be cleaned
satisfactorily must be:
1. packed in well sealed bags
2. disposed of in a manner that complies with
valid regulations for such waste removal.
A dust test must be performed at least once
every year by Nilfisk-Alto service or a trained
person. This test includes, for example,
whether there is damage to the filter, the
vacuum cleaner is sealed to the air and the
control equipment works properly.
Guarantee
Our general conditions of business are ap-
plicable with regard to the guarantee.
Unauthorised modifications to the appliance,
the use of incorrect brushes in addition to
using the appliance in a way other than for the
intended purpose exempt the manufacturer
from any liability for the resulting damage.
Tests and approvals
Electrical tests must be performed in accord-
ance with the provisions of safety regulations
(BGV A3) and to DIN VDE 0701 Part 1 and
Part 3. In accordance with DIN VDE 0702
these tests must be performed at regular
intervals and after repairs or modifications.
GB
D
F
NL
I
N
S
DK
SF
E
P
GR
TR
SLO
HR
SK
CZ
PL
H
RO
BG
RUS
EST
LV
LT
J
CN
ROK
T
11
MAL