Christopeit CX 6 - 9126 Montageanleitung Und Bedienungsanleitung Seite 24

Step 7:
Installation of the right (34) and left (28) footrest on the pedal tubes
(21+24).
1. Push the footrest (34) onto the pedal tube (24) so that the bores in (34)
are aligned with one of the possible installation positions in (24).
(Note. The high lip on the long side of the footrest must point inwards
(towards the main frame (1).)
2. Put one washer (29) on each carriage bolt (30) and push through the
bores from the top and fasten from the bottom with the washers (31),
the spring washers (32) and the knob down (33).
(Note. The position adjusted in this way should always be equal at
both sides. The positions can be changed as desired at all times by
removing the carriage bolts (30) and sliding the footrests on the footrest
brackets.)
3. Install the left footrest (28) with all additionally required parts on the
left hand side of the machine as described in 1. + 2.
Step 8:
Installation of the computer (48) and handle bar cover (50+51) on the
handlebar post (15).
1. Put the ends of the computer cable (14) and pulse cable (40) into the
socket at the backside of the computer (48).
2. Push the computer (48) onto the plate at the upper end of the handlebar
post (15).
(Note: When pushing on the computer, thread the cables in the bores
of the handlebar post (15) so that the cables cannot be trapped.
3. Put the front and back handlebar cover (50+51) onto the upper end of
handlebar post (15) together and fix them with screws (37+38).
Step 9:
Attach the power
1. Please insert the plug of adaptor (52) to the jack (103) of chain guard.
2. Please insert the adaptor (52) to the jack of wall power (230V/50Hz).
Step 10:
Checks
1. Check the orderly installation and function of all bolted and plug con-
nections. Installation is then complete.
2. When everything is in order, familiarise yourself with the machine at
a light resistance setting and make the individual adjustments of the
footrests (28) and (34).
Note: Please keep the tool set, the puller and the instructions carefully
because these may be required later for repairs or spare parts orders.
If you ever remove the covers (10) and (11), observe that these are attached
not only outwardly with the screws (64+65), but also inwardly at the rear end
of the cover with the screws (65).
24