CAMPAGNOLO Neutron Ultra Bedienunganleitung Seite 39

• Position the freehub close to the hub and hold it pressed
against the latter; lower one by one the three pawls with
an Allen wrench or a screwdriver and insert freehub fully
into its seat (Fig. 30).
• Tighten the locking nut (E - Fig. 31) with a 17 mm wrench,
holding the axle axle steady from the freehub side with
a snugly fitted 5 mm Allen wrench (approximate torque
setting: 15 N.m - 11 lb.ft).
• Adjust the hub as illustrated in section 7.
6.3 - REMOVING THE
FREEWHEEL BODY
Hold the axle steady by
fully inserting a 5 mm Allen
wrench on the freewheel
side (Fig. 32) and comple-
tely unscrew the nut by
turning it clockwise with a
17 mm wrench as shown
by the arrow marked on it;
then remove the small axle
body.
18
31
15 N.m - 11 lb.ft
30
CLOSE
32
OPEN