CAMPAGNOLO Neutron Ultra Bedienunganleitung Seite 34

• Insert the new spoke in the specific seat in the hub.
• If necessary, reposition the overlapping spoke, making sure that the overlap is correct
where the two meet.
Attention
After completing the operation, check that the flat spoke (aero) is oriented in an aerody-
namic position (Fig. 20).
• Following the operations described in Section 5 of the "Owner's Manual - PART 1":
- Tighten and Settle the Spokes;
- Check centering and wheel dishing.
• After having replaced the spoke and tensioned and centered the wheel, adjust the hub
(see section 7).
23
13