CAMPAGNOLO Neutron Ultra Bedienunganleitung Seite 27

4. REPLACING THE RIM
• Before commencing wheel disassembly operations, write on a piece of paper the original
layout of the rim and the spoke arrangement to ensure that the wheel can be re-assembled
correctly.
• Only use new, original Campagnolo
• Always prevent the rotation of the spokes when nuts are tightened or loosened. Make sure that
no damage is caused to the surface of the spokes.
• The water discharge hole must be on the side opposite the freewheel.
CAUTION!
Take special care when handling the spokes during assembly to
prevent accidentally scratching the rim.
• Using a 5 mm hex wrench, unscrew the nuts on all wheel
spokes by one turn (Fig. 4), holding them steady to prevent
rotation.
WARNING!
Using wheels that have not been centred properly or which
have broken or damaged spokes may result in accidents,
personal injury or death.
• For each spoke, completely unscrew the nut, remove the
pad and slide the spoke out of the rim.
• Fit the LH wheel spokes first and then the RH wheel spokes.
• The holes for the RH and LH spokes are not aligned but
slightly offset respectively to right and left.
NEVER FIT A LH SPOKE IN A RH HOLE AND VICE VERSA.
6
spare parts.
®
4
5 mm
3
5