How Do You Change The Bulbs; What Do You Do In Case Of Operating Malfunctions - De Dietrich DOP420-Serie Betriebsanleitung

99633771 ML.qxd 08/09/04
H
o w d o y o u c h a n g e t h e b u l b ?
• The bulb is located on the ceiling of your oven's cavity.
Disconnect your oven before performing any task on the bulb to
avoid the risk of electric shock and, if necessary, let the appliance
cool down.
a) Unscrew the view port (see adjacent
diagram).
b) Remove the bulb.
Bulb specifications:
- 25 W
- 220-240 V
- 300°
- G9
c) Replace the bulb then reposition the
view port and reconnect your oven.
W
hat do you do in case of operating
malfunctions?
If you have a doubt about the functioning of your oven, this does not
necessarily mean that there is a malfunction.
In any event, check the following items:
Y
ou notice that...
The oven is not heating.
The temperature indicator is
flashing.
The oven light is not working.
The pyrolysis cleaning cycle does
not begin.
40
09:05 Page 40
Unscrew
P
ossible causes
• The oven is not connected.
• The fuse in your electrical set-up
is not working.
• The selected temperature is too
low.
• Problem with the door's locking
mechanism.
• Defective temperature sensor
• The light is out of order.
• The oven is not connected or the
fuse is not working.
• The door is not properly closed.
• The locking system is defective.
Bulb
View port
W
hat should you do?
- Connect the oven.
- Replace the fuse in your electrical
set-up and check its capacity (16A).
- Increase the selected tempera-
ture.
- Call the After Sales Service
Department.
- Call the After Sales Service
Department.
- Replace the light.
- Connect the oven or replace the
fuse.
- Verify that the door is locked.
- Call the After Sales Service De-
partment.