Aligning The Appliance; Changing The Door Hinge - Bosch KTL Serie Montage- Und Gebrauchsanleitung

en

Aligning the appliance

Note
To ensure that it functions properly, the appliance must
be aligned using a spirit level.
1. Move the appliance into its intended installation
position.
2. Screw the feet in/out until the appliance is exactly
aligned.

Changing the door hinge

We recommend to have the door hinge changed by our
customer service. How much a door hinge change will
cost you can find out contacting customer service.
m
Warning
When the door hinge is changed, the appliance must
not be connected to the power supply. Please pull the
mains plug beforehand.
Required tools
20
8 mm hex nut driver
Cross-shaped screwdriver
Thin-blade screwdriver
Changing door hinge of the appliance
door
1. Open the appliance door and unhinge and remove
all fittings from inside the appliance (see section
headed Fittings).
2. Unscrew the 2 screws (1).
3. Take off the cover plate (2) and set it down on a
soft surface.
Hold on to the appliance door!
4. Unscrew the 2 screws (3).
5. Unscrew the 2 screws (4).
6. Remove the top hinge (5).
7. Unhook the appliance door and set it down on a
soft surface.
8. To avoid damaging the appliance rear side, provide
cushioning material. Place the appliance carefully
onto its rear side.