Maintenance And Servicing; Cleaning The Device - Siemens SIMATIC HMI KTP700F Mobile Arctic Produktinformation

Maintenance and servicing

The data in the operating instructions "Mobile Panels 2nd Generation" applies.
Note
Condensation endangers the interior of the device
After transporting the HMI device at low temperatures or if the HMI device has been exposed to temperature fluctuations,
moisture can condense on the HMI device or inside the device (condensation). The device can be damaged with
consequences for the machine or plant.
Adjust the HMI device to room temperature before opening the housing.
•
Do not expose the HMI device to direct radiation from a heater to warm it up.
•
In case of condensation, dry the HMI device completely or open it only after a waiting period of about 4 hours.
•

Cleaning the device

Note
Cleaning of the coated glass touch screen
Be careful not to damage the glass touch screen and the coating of the touch screen.
Use a cleaning cloth and dishwashing liquid or foaming screen cleaners. Apply as little pressure as possible on the touch
screen when cleaning.
Replacing the touch pen
The HMI device also has a front holder for a touch pen, see section "Overview". The following section describes how to
replace the touch pen.
Requirement
HMI device
•
A touch pen, article number
•
6AV6645-7AB14-0AS0
A T10 Torx screwdriver
•
Procedure
1. Remove the touch pen from its holder.
2. Remove the screw of the pen holder and take it out.
3. Remove the screw for fastening the strap and remove the strap.
Follow the steps in reverse order to install the new touch pen.
At the same time tighten the two screws with a torque of 0.3 Nm.
12
KTP700F Mobile Arctic
A5E49199858-AA, 02/2020