Maintenance And Servicing - Siemens SIMATIC HMI TP1000F Mobile Produktinformation

Maintenance and servicing

The data in the operating instructions "Mobile Panels 2nd Generation" applies.
The TP1000F Mobile also has a fixture on the front for a touch pen. The following section describes how to replace the touch
pen.
Replacing the touch pen
Requirement
You need the following to replace the touch pen:
HMI device
•
A touch pen, article number 6AV6645-7AB14-0AS0
•
A T10 Torx screwdriver
•
Procedure
1. Remove the screw of the pen holder and take it out.
2. Remove the screw that fastens the strap of the touch pen.
3. Remove the strap and the touch pen.
Follow the steps in reverse order to install the new touch pen.
Tighten both screws using a torque of 0.3 Nm.
8
TP1000F Mobile
A5E39831604-AA, 12/2017