Connecting To Tv; Inspection Equipment - RIDGID CA-350 Bedienungsanleitung

Connecting to TV

The micro CA-350 Inspection Camera can be
connected to a television or other monitor for
remote viewing or recording through the in-
cluded RCA cable.
Open the right side port cover (Figure 3).
Insert the RCA cable into the TV-Out jack.
Insert the other end of the cable into the Video-
In jack on the television or monitor. Check to
make sure the video format (NTSC or PAL)
output is set properly. The television or mon-
itor may need to be set to the proper input to
allow viewing. Select the appropriate TV-Out
format using the menu.
Use with SeeSnake

Inspection Equipment

The micro CA-350 Inspection Camera can
also be used with various SeeSnake Inspec -
tion Equipment and is specifically designed
to be used with the microReel, microDrain™
and the nanoReel Inspection Systems. When
used with these types of equipment, it retains
all of the functionality described in this manual.
The micro CA-350 Inspection Camera can
also be used with other SeeSnake Inspection
Equipment for viewing and recording only.
For use with SeeSnake Inspection Equip -
ment, the imager head and any cable exten-
sions must be removed. For the microReel,
microDrain™, nanoReel and similar equip-
ment, see the operator's manual for informa-
tion on proper connection and use. For other
SeeSnake Inspection Equipment (typically a
reel and monitor), an adapter must be used to
connect the micro CA-350 Inspection Camer a
to a Video-Out port on the SeeSnake Inspec -
tion Equipment. When connected in this man-
ner, the micro CA-350 Inspection Camera will
display the camera view and can be used for
recording.
When connecting to SeeSnake Inspection
Equipment (microReel, microDrain™, or nano -
Reel), align the interconnect module connected
to your reel with the cable connector on the
micro CA-350 Inspection Camera, and slide it
straight in, seating it squarely. (See Figure 18)
Figure 18 – Camera Connector Plug Installed
prevent damage.
Locating the Sonde
®
If used with a sonde (In-Line Transmitter), the
sonde can be controlled two ways. If the reel is
equipped with a sonde key, that can be used to
turn the sonde ON and OFF. Otherwise, the
sonde is turned ON by decreasing LED bright-
ness to zero. Once the Sonde has been lo-
cated, the LEDs can be returned to their nor-
mal brightness level to continue the inspection.
A RIDGID locator such as the SR-20, SR-60,
Scout
used to locate features in the drain being in-
spected.
Figure 19 – Locating the Reel Sonde
To locate the Sonde, turn the locator ON and
set it to Sonde mode. Scan in the direction of
the Sonde's probable location until the locator
detects the Sonde. Once you have detected
the Sonde, use the locator indications to zero
in on its location precisely. For detailed in-
structions on Sonde locating, consult the Oper -
ator's Manual for the locator model you are
using.
micro CA-350 Inspection Camera
Do not twist the connector plug to
NOTI E
® , or NaviTrack ® II set to 512 Hz can be
13