Defects; Overview - BADU 90 Eco Motion Pumpendatenblatt

Pos : 92 /T echnisc he Dokumentation/Betriebsanl eitung/Stör ung/Störungen @ 0\mod_1427964696943_370.doc x @ 27358 @ 1 @ 1
7

Defects

N O T IC E
It is normal for a few drops of water to escape from the
mechanical seal from time to time. This is especially true during
the break-in period.
Depending on the water quality and number of operating hours,
the mechanical seal can begin to leak.

If water pours out constantly, replace the mechanical seal.
N O T IC E
We recommend first informing the swimming pool contractor if
there are irregularities.
Pos : 94 /T echnisc he Dokumentation/Betriebsanl eitung/Stör ung/Ü bersicht @ 1\mod_1427966108756_370.doc x @ 27373 @ 2 @ 1
7.1

Overview

Problem
Pump is switched
off by the built-in
or external
overload switch.
Pump seizes.
Water is
constantly leaking
from the pump.
Loud motor noise.
Pos : 97 /T echnisc he Dokumentation/Betriebsanl eitung/Stör ung/Pumpe nach Ans prec hen eines Sc hutz kontakts/-sc halters pr üfen @ 1\mod_1427971162304_370.doc x @ 27388 @ 3 @ 1
10|2015
Possible
cause
Overload
Sticky
mechanical seal
because of
longer idle
period.
Mechanical seal
is leaking.
– Defective
ball
bearings.
– Direction of
rotation is
wrong.
Solution

Check pump. See
chapter 7.1.1 on
page 24.

Turn the motor
shaft. See chapter
6.2 on page 21.

Clean pump.

Replace the
mechanical seal.

Have a mechanic
replace the ball
bearings.

Inform an
electrician.
Defects
EN 23