Preventing Material Damage; Leakage And Pipe Breakage; Dry Running; Cavitation - BADU 90 Eco Motion Pumpendatenblatt

Pos : 36 /T echnisc he Dokumentation/Betriebsanl eitung/Sic herheit/Ver meidung von Sc häden/Vermei dung von Sac hschäden @ 0\mod_1427787266105_370.doc x @ 26782 @ 2 @ 1
2.9

Preventing material damage

Pos : 37 /T echnisc he Dokumentation/Betriebsanl eitung/Sic herheit/Ver meidung von Sc häden/Undichtigkeit und Rohrleitungsbr uch @ 0\mod_1427787655353_370.doc x @ 26797 @ 3 @ 1
2.9.1

Leakage and pipe breakage

Vibrations and thermal expansion can cause pipes to break.

Install the pump/unit in a manner which reduces structure-
borne and airborne noise transmission. When doing so,
observe relevant regulations.
If the pipe forces are exceeded, leaks can occur at the screwed
connection or the pump itself.

Do not use the pump as a fixed point for the pipe line.

Connect pipes free of load and mount them elastically. Install
compensators if necessary.

If the pump leaks, the unit may not be operated and must be
disconnected from the mains power supply.
Pos : 39 /T echnisc he Dokumentation/Betriebsanl eitung/Sic herheit/Ver meidung von Sc häden/Troc kenlauf @ 0\mod_1427789053644_370.doc x @ 26812 @ 3 @ 1
2.9.2

Dry running

If run dry, mechanical seals and synthetic parts can be destroyed
within only a few seconds.

Do not allow the pump to run dry. This also applies to
checking the rotation direction.

Purge air from pump and suction line prior to start-up.
Pos : 41 /T echnisc he Dokumentation/Betriebsanl eitung/Sic herheit/Ver meidung von Sc häden/Kavitation @ 0\mod_1427790036391_370.doc x @ 26832 @ 3 @ 1
2.9.3

Cavitation

Pipes which are too long increase resistance. This results in risk
of cavitation.

Ensure that the suction line does not leak.

Observe the maximum pipe length.

Only switch the pump on when the valve on the delivery side
is opened halfway.

Open the valve on the suction side completely.
Pos : 43 /T echnisc he Dokumentation/Betriebsanl eitung/Sic herheit/Ver meidung von Sc häden/Überhitzen @ 0\mod_1427790847604_370.doc x @ 26847 @ 3 @ 1
2.9.4

Overheating

The following factors can result in the pump overheating:
• Excessive pressure on the delivery side.
• Motor overload switch set incorrectly.
• Ambient temperature which is too high.

Do not operate the pump with the valves closed, minimum
flowrate 10 % of Qmax.
10|2015
Safety
EN 11