Werbung
fig.05-13e_30
5
In the dialog box that appears,
input the following into the
"Open" field, and click [OK].
D:\DRIVER\USB_ME98\SETUPINF.EXE
* The drive name "D:" may be different depending on your system. Type the name of
your CD-ROM drive.
fig.05-14e_30
6
Open the SetupInf dialog box.
You are now ready to install the
driver.
7
Use the USB cable to connect the
UA-700 to your computer.
1. With the power switch
turned OFF, connect the AC
adaptor to the UA-700.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the UA-700 to your computer.
fig.advance-on
8
Set the UA-700's ADVANCE (mode select)
switch to the ON position.
9
Set the UA-700's power switch to the ON
position.
Near the task bar, your computer will indicate "Found New Hardware".
Please wait.
fig.05-15e_30
10
If you are using Windows 98, an
Insert disk dialog box will
appear.
Click [OK].
Getting Connected and Installing Drivers (Windows)
In this manual, the
location of folders and
files is given in terms of
the file path, using \ as the
delimiter.
For example,
USB_ME98\SETUPINF.
EXE indicates that the
SETUPINF.EXE file is
located in the USB_ME98
folder.
Once the connections
have been completed,
turn on power to your
various devices in the
order specified. By
turning on devices in the
wrong order, you risk
causing malfunction and/
or damage to speakers
and other devices.
Advance mode is
ON
This unit is equipped
with a protection circuit.
A brief interval (a few
seconds) after power up
is required before the unit
will operate normally.
If you are using
Windows 98 and the
Insert disk dialog box
dose not appear, please
read The "Insert Disk"
dialog box does not
appear (p. 242).
27
Werbung
Kapitel
