Werbung
I Guitar Amp Modeling section
NProcedureN
fig.02-1
1. Turn the Model knob to select the guitar amp that
you want to adjust.
2. Press and hold the Guitar Amp Modeling switch for
at least three seconds.
The Guitar Amp Modeling switch and the Guitar
Effects switch will blink, and the UA-700 will enter a
mode that lets you adjust the Guitar Amp Modeling
custom parameters.
3. With the indicators of the Guitar Amp Modeling
switch and Guitar Effects switch both blinking,
turn the Guitar Effects section Effect control
knobs 1–3 (p. 121) to adjust each custom parameter.
Effect control knob 1
Effect control knob 2
Effect control knob 3
4. Press the Guitar Amp Modeling switch once again to make it light.
The Guitar Effect Switch will stop blinking, and you will exit the custom parameter
adjustment mode.
*
The custom parameters you adjusted will return to the factory settings when the power is turned off.
*
You can make independent settings for each of the eleven different guitar amp models.
I Compressor/De-esser section
NProcedureN
fig.02-2
1. Turn the
Compressor type
select knob to select
the compressor type
that you want to
adjust.
2. Press and hold the
Compressor/De-
esser switch for at least three seconds.
The Compressor/De-esser switch and the Guitar Effects switch will blink, and the UA-700
will enter a mode that lets you adjust the Compressor's custom parameters.
Level
Pre-drive
Edge
2
4
1
Advanced applications
1
2
4
3
3
139
Werbung
Kapitel
