Werbung
Names of things and what they do
GLoading a patchG
On the UA-700, the settings of the mic modeling section, compressor & de-esser section, guitar amp
modeling section, guitar effect section, noise suppressor & equalizer section, reverb & chorus
section, LO-CUT switch, and center cancel switch settings can be loaded from one of six patches.
*
After a patch has been read, the settings will not match the positions of the panel knobs. Be aware of this
when continuing to adjust the settings.
1. Press the Patch Mode switch.
The Patch Mode switch will blink, and the UA-700 will be ready to load a patch.
2. Turn the Sample rate/patch select switch to select the patch (number) that you want to
load.
If you press any switch other than the Patch Mode switch, the Patch Mode switch will go dark. You will
exit Patch mode and return to the previous state; i.e., the state prior to beginning the patch loading process.
3. Press the Patch Mode switch.
The Patch Mode switch will blink more rapidly, and will go dark when the patch has been loaded.
When you load a patch, all parameters of the patch will be transmitted to your computer in the
form of a bulk dump. You can record this bulk dump into your sequencer software in order to save
UA-700 patch parameters on your computer. In your sequencer software, select [EDIROL UA-700
CONTROL] as the MIDI port.
GSaving a patchG
On the UA-700, the settings of the mic modeling section, compressor & de-esser section, guitar amp
modeling section, guitar effect section, noise suppressor & equalizer section, reverb & chorus
section, Lo-Cut switch, and center cancel switch settings can be saved into one of six patches.
1. Use the knobs of each section to create the desired sound.
2. Hold down the Patch Mode switch, and press the Sequencer Control switch.
The Patch Mode switch will light, and the Sequencer Control switch will blink, indicating that the
UA-700 is ready to save a patch. The current settings of the panel knobs and switches can now be saved.
3. Turn the Sample Rate/Patch Select knob to select the patch (number) that you want to save.
*
If you press any switch other than the Sequencer Control switch, the Patch Save operation will be cancelled. The Patch
Mode switch will go dark, and you will exit Patch mode.
4. Press the Sequencer Control switch.
The Sequencer Control switch will blink more rapidly, and will go dark when the patch has been saved.
126
Werbung
Kapitel
