Werbung
fig.05-5e_30
10
In the dialog box that appears,
input the following into the
"Open" field, and click [OK].
D:\DRIVER\USB_XP2K\WDM\SETUPINF.EXE
* The drive name "D:" may be different for your system. Specify the drive name of your
CD-ROM drive.
fig.05-6e_30
11
The SetupInf dialog box will
appear.
You are now ready to install the
driver.
12
Use the USB cable to connect the UA-700 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
UA-700.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the UA-700 to your computer.
fig.advance-on
13
Set the UA-700's ADVANCE (mode select)
switch to the ON position.
14
Set the UA-700's power switch to the ON position.
Near the task bar, your computer will indicate "Found New Hardware".
Please wait.
Getting Connected and Installing Drivers (Windows)
In this manual, the location
of folders and files is given
in terms of the file path,
using \ as the delimiter.
For example,
WDM\SETUPINF.EXE
indicates the
SETUPINF.EXE file found
in the WDM folder.
If you are using the MME
driver, input MME
instead of WDM.
Once the connections
have been completed,
turn on power to your
various devices in the
order specified. By
turning on devices in the
wrong order, you risk
causing malfunction and/
or damage to speakers
and other devices.
Advance mode is
This unit is equipped
ON
with a protection circuit.
A brief interval (a few
seconds) after power up
is required before the unit
will operate normally.
23
Werbung
Kapitel
