Inhaltsverzeichnis
Werbung
Operating tips
S The sides of the housing are sometimes
heated slightly. This prevents
condensation in the area of the door
seal.
S While the refrigerating unit is running,
beads of water or hoarfrost form at the
back of the refrigerator compartment.
This is quite normal. It is not necessary
to scrape off the frost or wipe off the
beads of water. The rear panel defrosts
automatically. The condensation is
conveyed down the drainage channel,
(Fig. 8/A) to the refrigerating unit
where it evaporates.
S If the air humidity is high, condensation
may form in the refrigerator compart
ment, especially on the glass shelves.
If this is the case, pack or wrap the food
and select a lower temperature in the
refrigerator compartment.
S If you cannot open the freezer
compartment door immediately after
closing it, wait 2 3 minutes until the
partial vacuum has equalised.
S The refrigeration system may cause
several areas of the freezer shelves
to frost quickly. This does not affect
function or power consumption.
The appliance does not require
defrosting until the entire surface of
the freezer shelf is covered with more
than 5 mm of frost or ice.
Fridge section
Adjusting the temperature
You can adjust the required temperature
in the range of +11 C to +2 C (factory
setting +4 C) for the fridge section.
To change the required temperature:
S Touch the fridge section button.
S Use the < or > buttons to adjust the
temperature to the required value.
S Acknowledge with ok.
Super
Super cooling cools the refrigerator
compartment as cold as possible for
approx. 6 hours (+2 C). Then the
temperature set before super mode is
automatically restored. Switch on super
mode, e.g.:
- before inserting fresh food,
- to cool drinks quickly.
To switch on super mode:
S Touch the super/fridge section button.
Super mode is on when the message and
the new required temperature are on the
standard display.
Note
Also follow the storage recommendations
which you are given via the appliance
control.
en
35
Werbung
Inhaltsverzeichnis
