Inhaltsverzeichnis
Werbung
Observe ambient
temperature and
ventilation
The climatic class can be found on the
rating plate (Fig. 0). and indicates the
ambient temperatures at which the
appliance can be operated.
Climatic class
SN
N
ST
T
Ventilation
Fig. 3
The air on the rear panel of the appliance
heats up. The warm air must be able to
escape. Otherwise, the refrigerator must
work harder. This will increase the power
consumption. Therefore: Never cover or
block ventilation openings!
Permitted ambient
temperature
+10 C to 32 C
+16 C to 32 C
+18 C to 38 C
+18 C to 43 C
Connecting the
appliance
After installing the appliance, wait at least.
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
To enable your refrigerator to be used with
serve@Home, you will require a special
accessory, the system interface, which is
available from specialist outlets.
The system interface must be inserted
into the slot at the rear of your refrigerator.
Follow the installation instructions
enclosed with the system interface.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to 220 240 V /
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 A fuse or higher.
If the appliance is to be operated in
a non European country, check on the
rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may be
replaced by an electrician only.
Warning!
!
Never connect the appliance to elec
tronic energy saver plugs (e.g. Eco
boy: Sava Plug) or to power inverters
which convert the direct current to
230 V alternating current (e.g. solar
equipment, power supplies on ships).
en
29
Werbung
Inhaltsverzeichnis
