Hartan Skater S Bedienungsanleitung Seite 20

Instructions
Automatic lock for upper section 19
Place the carrycot or stroller unit upon the chassis in a way that the two lateral
pins engage in the respective slots on each side. Then push the upper section
right up to the stop. The catching pins on both sides engage automatically,
which is indicated each time by a click sound.
WARNING! By pulling the upper section, check before use whether it is
fixed securely! If the red safety point can still be seen, the upper-section lock
has not yet completely closed!
Pull the locking lever downwards until it snaps into place to open the lock
and to remove the upper section.
Fall-out protection
WARNING!
As an additional protection pre-
venting the baby from falling out 18
of the carriage, secure the hood to
the metal back. To do this, join the
17
17
two grommets 17 to their respective
turn-lock fasteners, and the hook
lock 18 to the metal ring on the
13
back plate as well.
Adjusting the backrest
By lifting the back clip 13 at the rear, the backrest can be adjusted from
sitting to reclining position in close steps.
WARNING! When adjusting the backrest, take care no movable parts
jam the baby's limbs, or fingers, etc. Finally, make sure the backrest has
reengaged properly.
Suitability for your child
The Skater S stroller unit is designed to carry a child from the age of 6 months,
and up to 15kg in weight.
WARNING!
Only use this seat unit when your child is able to sit independently.
The Skater S stroller is not suitable for children under the age of 6 months
except in connection with an appropriate carrycot.
16