Hartan Skater S Bedienungsanleitung Seite 19

Instructions
Hood and safety bar
By pressing the bayonet joint 12, the hood or the safety bar can be pulled
out. When inserting it, make sure the safety bar locks into place correctly
and be careful not to pinch any of the fabric parts. By pressing the buttons
the safety bar position can be changed.
WARNING! The hood bar 10 of the stroller and the safety bar are not
suitable for carrying the pram.
Safety belt
14
WARNING! Use the safety belt 14 for
your child. Always use the crotch belt
D in combination with the waist strap E.
Remember to tighten the seat belt when
it slacks, which is done by means of the
adjuster buckles. For reasons of safety,
pass the belt buckle through the shackle
F when closing the safety belt.
As an additional protection preventing
babies from slipping out, pass the
crotch belt D through the loop G on
14
the seat. Unfasten the belt: To unfasten
the belt, press the red point A and the
two latches B as well. To unfasten the
shoulder straps, press the buttons C.
Adjusting the footrest
First, press the two buttons 15, located
at the right and left side respectively,
to fold the footrest down. Then raise the
footrest to the required position.
A number of settings up to the horizontal
position can be selected. To prolong the
footrest, press the two buttons 16, and
pull it out. WARNING! In case the carry-
cot is attached to the frame, the footrest
G
should always be in horizontal position,
as an additional protection preventing it
D
from slipping out.
15