Hartan Skater S Bedienungsanleitung Seite 17

Instructions
Unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the handle in
horizontal position. Pull handle 1 upwards until handle catch 2 has engaged.
WARNING! Before using the pram, make sure all catches are locked.
Folding the pram
Turn safety turn-lock 3 inward until the handle's catch 1 has released.
Push handle downwards to fold the pram. By pushing the lock buttons 4, fold
the handle's upper section inward.
WARNING! We recommend proceeding with caution when folding and
unfolding the chassis, and adjusting the backrest, as there is a risk that you
do yourself an injury such as jamming your limbs, fingers, etc.
Height adjustment of handlebar
Press the two handle-folding lock buttons 4 to bring the upper section of the
handlebar 1 in the desired position.
Changing of wheels
Release the parking brake. Push the button 5 to release the retention,
and pull off the wheel. Push the wheel right to the axle's stop, then depress
the button. Make sure, all wheels are held in place properly.
Lock-type-swivel wheel
Turn the cap 6 so that the red point faces forward to pre-select the straight-
line motion mode, which will be activated the moment the wheel points in for-
ward direction. Turn the cap so that the green point faces in forward direction
to release the swivel lock. To remove the wheel, open the push-button, which
is located inside the cap, by depressing it, and pull the wheel off the holding
device. To assemble the wheel, the push-button must be open. Insert the
wheel unit's fastening pin in the holding device, and depress the push-button.
With the holding device closed, the button must not protrude anymore.
Sun canopy
Press the two front hood bows together 10 to adjust the hood. Adjusting the
hood can be effected silently. By taking off the rear hood section 11, the hood
can be converted into a sun canopy by means of a zip fastener. As an additi-
onal protection,the sun visor can be pulled out.
13