VOLTCRAFT B6 Dual Power Bedienungsanleitung Seite 84

As soon as a charge process starts, the internal timer starts as well. If the charger cannot
detect whether the accumulator is fully charged for whatever reason (e.g. with delta-U
detection), the charge process is terminated automatically after a set time if the safety timer
is set to ON.
This protects the accumulator from overloading. However, do not set the time too short,
otherwise the accumulator will not be fully charged.
Calculate the time for the safety timer as follows:
Example:
Accumulator capacity
2000mAh
3300mAh
1000mAh
With factor 11.9, the accumulator is charged with 140% capacity before the safety timer kicks
in.
Briefly press the button "Start/Enter". "ON" (or "OFF") starts to blink in the bottom display line.
With the buttons "INC" or "DEC", you can select between "ON" (= safety timer activated) and
"OFF" (safety timer deactivated).
Save the setting by pressing the "Start/Enter" button.
Now the time for the safety timer starts to blink in the bottom line on the right.
With the buttons "INC" or "DEC", you can select the time (10 to 720 min). For a quick
adjustment, hold the corresponding button for a longer period of time.
Save the setting by pressing the "Start/Enter" button.
• With the "INC" button, you access the next setting (or with the button "DEC" the previous
setting). Return to the main menu with the button "Batt Type/Stop".
Capacity Cut-OFF Capacity Cut-OFF Capacity Cut-OFF
Capacity Cut-OFF Capacity Cut-OFF
ON ON
ON ON ON
Another safety function of the charger can terminate the charge process if a certain capacity
was "loaded" into the accumulator.
Briefly press the button "Start/Enter". "ON" (or "OFF") starts to blink in the bottom display line.
84
Charge current
2.0A
3.0A
1.2A
5000mAh 5000mAh
5000mAh 5000mAh 5000mAh
Timer time
2000 / 2.0 = 1000 / 11.9 = 84 minutes
3300 / 3.0 = 1100 / 11.9 = 92 minutes
1000 / 1.2 = 833 / 11.9 = 70 minutes