VOLTCRAFT B6 Dual Power Bedienungsanleitung Seite 82

• With the "INC" button, you access the next setting (or with the button "DEC" the previous
setting). Return to the main menu with the button "Batt Type/Stop".
NiMH Sensitivity NiMH Sensitivity
NiMH Sensitivity NiMH Sensitivity NiMH Sensitivity
D.Peak 10mV/Cell D.Peak 10mV/Cell D.Peak 10mV/Cell
D.Peak 10mV/Cell D.Peak 10mV/Cell
Here you can set the sensitivity of the delta-U detection of NiMH accumulators (voltage
difference in the delta-U charge procedure).

An excess value may overcharge the accumulator. If the value is not high
enough, the accumulator may not be charged sufficiently.
Briefly press the button "Start/Enter". The voltage value then begins to flash.
With the buttons "INC" or "DEC", you can select the voltage value (5 to 20mV). If you select
"DEFAULT", the charger uses a voltage of 7mV.
Save the setting with the button "Start/Enter"; the voltage stops blinking.
• With the "INC" button, you access the next setting (or with the button "DEC" the previous
setting). Return to the main menu with the button "Batt Type/Stop".
NiCd Sensitivity NiCd Sensitivity
NiCd Sensitivity NiCd Sensitivity NiCd Sensitivity
D.Peak D.Peak D.Peak
D.Peak D.Peak
Here you can set the sensitivity of the delta-U detection of NiCd accumulators (voltage
difference in the delta-U charge procedure).

An excess value may overcharge the accumulator. If the value is not high
enough, the accumulator may not be charged sufficiently.
Briefly press the button "Start/Enter". The voltage value then begins to flash.
With the buttons "INC" or "DEC", you can select the voltage value (5 to 20mV). If you select
"DEFAULT", the charger uses a voltage of 12mV.
Save the setting with the button "Start/Enter"; the voltage stops blinking.
• With the "INC" button, you access the next setting (or with the button "DEC" the previous
setting). Return to the main menu with the button "Batt Type/Stop".
USB/Temp Select USB/Temp Select USB/Temp Select
USB/Temp Select USB/Temp Select
Temp Cut-Off 80C Temp Cut-Off 80C
Temp Cut-Off 80C Temp Cut-Off 80C Temp Cut-Off 80C
The small 3-pole connection on the left side of the charger serves to connect a temperature
sensor (not part
82
Default Default Default
Default Default
of the delivery, must be ordered separately).