VOLTCRAFT B6 Dual Power Bedienungsanleitung Seite 67

If you do not, the following display appears (alternating):
R: 3SER R: 3SER R: 3SER
R: 3SER R: 3SER
CONFIRM(ENTER) CONFIRM(ENTER)
CONFIRM(ENTER) CONFIRM(ENTER) CONFIRM(ENTER)
The "R" value indicates the number of cells detected by the charger.
The "S" value indicates the number of cells set in the menu.
If these two numbers do not match, please check the settings on the charger
and the accumulator itself. It may be that the LiPo accumulator has been
completely discharged, or a cell may be defective. In this case, the accumulator
should not be charged, as there is a risk of fire and explosion!
You can return to the previous configuration menu using the "Batt Type/Stop"
button.
• If the two numbers match, you can start the charging process by quickly pressing the "Start/
Enter" button.
• Once the charging process has been started, various pieces of information about the current
charging progress are displayed, see next image:
Example:
Number of cells
Li3S 1.2A 12.59V Li3S 1.2A 12.59V
Li3S 1.2A 12.59V Li3S 1.2A 12.59V Li3S 1.2A 12.59V
CHG 022:43 00682 CHG 022:43 00682 CHG 022:43 00682
CHG 022:43 00682 CHG 022:43 00682
Current charging duration
• Once the charging process has been completed, an audio signal is emitted (if not turned off).

If you wish to terminate the charging process beforehand, press the "Batt Type/
Stop" button.
S: 3SER S: 3SER S: 3SER
S: 3SER S: 3SER
Charge current
Charge capacity in mAh
R: 3SER R: 3SER R: 3SER
R: 3SER R: 3SER
CANCEL(STOP) CANCEL(STOP)
CANCEL(STOP) CANCEL(STOP) CANCEL(STOP)
Accumulator voltage
S: 3SER S: 3SER S: 3SER
S: 3SER S: 3SER
67