VOLTCRAFT B6 Dual Power Bedienungsanleitung Seite 63

• Have you selected the correct charging program for the type of accumulator
you are using? Selecting the wrong settings will damage the charger and the
accumulator and present a risk of fire and explosion!
• Have you selected the appropriate charge current?
• Have you selected the correct voltage (e.g. for multiple-cell LiPo batteries)?
A dual-cell LiPo accumulator can, under certain circumstances, be connected
in parallel (3.7V) or in series (7.4V).
• Are all connector cables and plugs undamaged, do the plugs stay firmly in
the sockets? Worn-out plugs and damaged cables should be replaced.
• When connecting a accumulator to the charge, always connect the charging
cable to the charger first, then the accumulator to the charger/charging cable.
When disconnecting, do so in reverse order to the above. Failure to do so
presents the danger of a short circuit (e.g. from the two 4mm circular
connectors on the charging cable).
• Only ever charge one accumulator or accumulator pack at a time.
• If you wish to charge accumulator packs that you have manufactured
yourself, the cells must be identical in their construction (same type, same
capacity, same manufacturer). The cells must also be charged to the same
level (LiPo batteries can be balanced out using the balancer, this is,
however, not possible with other accumulator packs such as NiMH or NiCd).
Operating the menus (overview see chapter 10):
• Select the desired submenu from the main menu using the "Batt Type/Stop" button as
described and confirm your selection with the button "Start/Enter".
• Using the buttons "INC" and "DEC", the various configuration options can be called up.
• To modify a value, press the "Start/Enter" button - the display then flashes.
• Modify the value displayed using the "INC" and "DEC" buttons.
• Save the (modified) value with the "Start/Enter" button.
• Exit the configuration menu using the "Batt Type/Stop" button. It then returns to the main
menu.
63