Maxwell MW-3048 VT Die Betriebsanweisung Seite 10

ENGLISH
STEAM IRON MW-3048 VT
The iron is intended for ironing clothes and bedding
as well as for vertical steaming of fabrics.
DESCRIPTION
Water spray nozzle
1.
Water inlet lid
2.
Continuous steam supply / Self-clean knob
3.
Water spray button
4.
Burst of steam button
5.
Handle
6.
Power cord protection
7.
Pilot lamp of the heating element
8.
Base
9.
Temperature control knob
10.
Water tank
11.
"MAX" water level mark
12.
Soleplate
13.
Beaker
14.
SAFETY MEASURES
Before using the unit, read this instruction manual
carefully and keep it for future reference.
Use the unit for intended purposes only, as speci-
fied in this manual. Mishandling the unit can lead to
its breakage and cause harm to the user or damage
to his/her property.
•
Before plugging the unit in, make sure that volt-
age of your mains corresponds to the operating
voltage of the iron.
•
The power cord is equipped with a "europlug";
plug it into the socket with a reliable ground-
ing contact.
•
To avoid fire or electric shock, do not use
adapters for plugging the unit in.
•
To avoid mains overloading, do not switch on
several electrical appliances with high power
consumption at a time.
•
Do not fill the water tank with scented liquids,
vinegar, starch solution, descaling reagents,
chemicals etc.
•
Do not place the power cord on the ironing
board and do not let it touch hot surfaces.
•
Do not leave the unit unattended. During breaks
in operation, put the iron on the base (in verti-
cal position).
•
Before plugging/unplugging the iron, set the
temperature control knob to the minimum posi-
tion and switch the continuous steam supply
off.
MW-3048.indd 10
•
Always unplug the iron when you are not using
it.
• To unplug the unit always pull its plug, but not
the cord.
•
To avoid electric shock, do not immerse the
iron, the power cord and the plug into water or
any other liquids.
• Before taking the iron away, let it cool down
completely and pour out the remaining water.
•
Clean the unit regularly.
•
Do not immerse the unit body, the power plug
or the power cord into water or other liquids.
• Do not touch the unit body and the power
plug with wet hands.
•
Do not allow children to touch the unit body
and the power cord during the unit operation.
•
Do not leave children unattended to prevent
using the unit as a toy.
• For children safety reasons, do not leave poly-
ethylene bags used as packaging unattended.
Attention! Do not allow children to play with poly-
ethylene bags or packaging film. Danger of suf-
focation!
• Do not disassemble the unit by yourself, if any
malfunction is detected or after the iron was
dropped, apply to the nearest authorized ser-
vice center.
•
Transport the unit in the original package only.
• Keep the unit out of reach of children and dis-
abled persons.
•
During ironing and after it do not touch the unit
surface marked with the
burns.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE
ONLY
BEFORE THE FIRST USE
After unit transportation or storage under cold
(winter) conditions, it is necessary to keep
it for at least two hours at room temperature
before switching on.
•
Unpack the iron; remove the protection from
the iron soleplate (13), if any.
• Check the unit for damages; do not use the iron
in case of damages.
•
Before switching the unit on, make sure that
your home mains voltage corresponds to the
unit operating voltage.
• There may be water residue in the tank, this is
normal, as the iron has undergone factory qual-
ity control.
10
symbol. Danger of
28.08.2014 11:37:58