Installation; Installing The Appliance - AEG Electrolux MCC 4060 E Gebrauchsanweisung

1. AG-91D-EU ENGLISH

Installation

INSTALLING THE APPLIANCE

1. Remove all packaging and check carefully for any
signs of damage.
2. If the microwave is fitted in position C, ensure that
the minimum air gaps are maintained as shown in
the diagram.
3. Secure four cupboard retention blocks in position
using the setting template (TMAPTA004URR0).
4. Fit the appliance into the kitchen cupboard, lift over
the bottom/front blocks then push slowly, and
without force, until the front frame of the oven
seals against the front opening of the cupboard.
5. Ensure the appliance is stable and not leaning.
6. Fix the oven in position with the screws provided.
The fixing points are located within the louvre areas
at the top and bottom of the oven (see diagram,
item 1, on page 4).
7. Fit the frame fastner caps to the four fixing
positions (2 spare caps are provided).
8. It is important to ensure that the installation of this
product conforms to the instructions in this
operation manual and the conventional oven or hob
manufacturer's installation instructions.
The microwave can be fitted in position A, B or C:
Chimney
Position A
Conventional
oven
POSITION NICHE SIZE
W
A 560 x 550 x 450
B 560 x 550 x 450
C 560 x 550 x 460
38
21/02/2005 16:23 Page 38
Cable clip
Position C
CHIMNEY
D H (min) Cupboard & Ceiling
20
20
20
Position A
Conventional
oven
Chimney
Cable clip
Position B
D
Gap Between
50
50
Not Applicable
Measurements in (mm)
Position B
65 mm
Position C