Herunterladen Inhalt Inhalt Diese Seite drucken

Installation - AEG Electrolux MCD1751E Gebrauchsanweisung

Mikrowellengerät mit grill
Vorschau ausblenden Andere Handbücher für MCD1751E:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. AG-61+62D-EU English

Installation

INSTALLING THE APPLIANCE
1. Remove all packaging and check carefully for any
signs of damage.
2. This oven is designed to fit into a 360mm high
cupboard as standard.
When fitting into a 350mm high cupboard:-
Unscrew and remove the 4 feet from the bottom of
the oven. There are 3 tall feet and 1 short foot.
Replace the 3 tall feet with those provided in the
accessory pack. Do not replace the short foot.
3. If fitting the microwave oven above a conventional
oven (position A) then use the mylar sheet provided.
a. Cut the Mylar sheet to
fit the internal
width of the
unit.
b. Peel back the
protective
cover on the
tape and fix
to the rear of
the shelf so
that it covers
the service gap.
(See diagram).
SAFE USE OF THE APPLIANCE
If fitting the microwave in position B or C:
• The cupboard must be a minimum of
500mm (E) above the worktop & must not
be installed directly above a hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
• Sufficient space between hob and
microwave should be allowed to prevent
overheating of microwave oven,
surrounding cupboard and accessories.
• Do not operate the hob without pans
when the microwave oven is operating.
• Care should be taken when attending to
the microwave oven while the hob is on.
42
30/03/2005
16:35
Mylar sheet
Conventional
oven
Position A
Conventional
oven
POSITION
A
B + C
D
Measurements in (mm)
Page 42
4. Fit the appliance into the kitchen cupboard slowly,
and without force, until the front frame of the oven
seals against the front opening of the cupboard.
5. Ensure the appliance is
stable and not leaning.
Ensure that a 5mm gap is
kept between the cupboard
door above and the top of
the frame (see diagram).
6. Fix the oven in position with the
screws provided.
The fixing points are located on
the top and bottom corners of
the oven (see diagram, item 10,
on page 5).
7. It is important to ensure that the installation of this
product conforms to the instructions in this
operation manual and the hob or conventional oven
manufacturer's installation instructions.
NOTE: Ensure the bottom of the oven is
85 cm or more above the floor.
Chimney
Position B
E
NICHE SIZE
CHIMNEY
W
D
H
(min)
560 x 550 x 360
460 x 300 x 350
460 x 300 x 360
560 x 300 x 350
560 x 300 x 360
460 x 500 x 350
460 x 500 x 360
560 x 500 x 350
560 x 500 x 360
5 mm
Chimney
Position C
Position D
D
Gap Between
Cupboard & Ceiling
50
50
15
50
15
50
15
50
15
50
40
50
40
50
40
50
40
50

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Mcd1761e

Inhaltsverzeichnis