Troubleshooting Guide - Teka TFI 130 D Gebrauchsanweisung

Trouble-Shooting Guide
During the service, you can come across some troubles that in most
cases result from improper handling of the appliance and can easy be
eliminated.
The Appliance Fails to Operate After Connecting to the
Mains Supply
• Check the supply in the outlet socket and make sure the appliance is
switched on (thermostat knob in operating position).
Continuous Operation of the Cooling System
• The door was frequently opened or it was left opened for too long.
• The door is not properly closed (the door may sag, the gasket may be
polluted or damaged).
• Perhaps you have overloaded the appliance with fresh foods.
• Insufficient cooling of compressor and condenser.
Check the air circulation through the bottom rail openings and if
necessary clean or vacuum the dust from the condenser. See
Section Cleaning and Maintenance.
Ice Formation on the Inner Rear Wall
Until the water is drained through the hole in the rear and into the
receptacle at the bottom of the appliance, normal automatic defrosting
of the appliance is guaranteed.
In case the ice formation on the inner back wall is increased (3-5 mm),
ice should be manually defrosted.
Set the thermostat knob to STOP (0) position and leave the door open.
Never use electric devices for defrosting and do not scrape the ice or
frost layer with sharp objects.
After completed defrosting, turn the knob to desired position and close
the refrigerator door.
The cause of increased ice formation may be one of the following:
− the door does not seal well (clean the gasket if it is contaminated, or
replace it if it is damaged);
− the door was frequently opened or it was left opened for too long;
− the food stored in the refrigerator was warm;
− the food or dish is touching the inner back wall.
Installation instructions 53