Selection Of The Reference Point; End Piece Reference Point - Parkside PLEM 50 B2 Bedienungs- Und Sicherheitshinweise

Press "Return / Clear" button
Home-screen (see chapter "Start-up", section "Home-screen
mode").
Note: Pressing "Return / Clear" button
measurement mode will stop the measurement.

Selection of the reference point

The rear reference point
point or the front reference
as the contact surface for any measurement. The reference point is
to be set before measurement. Otherwise, the measured result dif-
fers from actual value. The default reference point setting is from
the reference point (rear)
can be changed by pressing the reference button
until the desired reference point shown on the top left side corner
of the display.

End piece reference point

The end piece
33
a corner (diagonal room) or from the place, where it is difficult to
reach. The end piece
The end piece
33
sharp tool or finger nail. Once finished using, the end piece
has to be folded-back for future use.
8
(base) or the end piece
29
point of the product can be used
30
of the product. The reference point
29
will be useful while a distance is measured from
is located on the rear side of the product.
33
can be unfolded as shown in the fig D using a
multiple times to go back to
under continuous
8
12
reference
28
repeatedly
33
GB 17