Disc Playback; Remote Control - Yamaha CRX-330 Bedienungsanleitung

Disc Playback

Problem
Power turns on but The power cable is not connected or the
immediately shuts plug is not completely inserted.
off.
No sound or
The sampling rate of a MP3 or WMA file
distorted sound may not be compatible with this unit.
Disc playback does
You may use a CD-R/RW that is not
not start. finalized.
The disc label may not be facing up.
The disc may be defective.
MP3/WMA disc may not contain
sufficient music tracks to be played back.
The sampling rate of a MP3 or WMA file
may not be compatible with this unit.
USB playback does
Improper USB device connections.
not start.
The MP3 or WMA formats are not
compatible with this unit.

Remote control

Problem
The remote control The remote control may be operated
does not work nor outside its operation range.
function properly.
The remote control sensor on this unit
may be exposed to direct sunlight or
lighting (invented fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
this unit and the remote control.
Cause
Connect the power cable firmly.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with this unit.
Finalize the CD-R/RW.
Check that the disc label is facing up.
Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
Check that your MP3/WMA disc contains at least 5
MP3/WMA music files. If the number of files is
small, the disc may not be recognized.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with this unit.
Connect the USB device again.
Replace the file with a correctly recorded file
playable with this unit.
Cause
For information on the remote control operation
range, refer to "Using the remote control".
Change the lighting or orientation of this unit.
Replace the battery with new one.
Remove the obstacles.
TROUBLESHOOTING
Remedy
Remedy
See
page
11
28
—
—
—
—
28
12
28
See
page
8
—
8
—
27
En