Before Starting The Equipment; Operation; Replacing The Power Cable - Parkside 42.585.82 Bedienungs- Und Sicherheitshinweise

Anleitung_BMR_1400_4258582:_
GB/IE/
CY
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to
hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Mixing of paint and mortar
Vibration emission value a
K uncertainty = 1.5 m/s 2
Important!
The vibration value changes according to the
area of application of the electric tool and may
exceed the specified value in exceptional
circumstances.

7. Before starting the equipment

Important!
Before you connect the equipment to the
mains supply make sure that the data on the
rating plate are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Assembly of the mixing tool (Fig. 2):
Screw mixing tool part (6a) securely to mixing
tool part (6b). Then screw the mixing tool (6)
into the mount (5).
Use 2 open ended wrenches to do this (4).
With one open ended wrench, hold the mount
(5) securely. With the other, tighten the mixing
10
29.01.2009 9:47 Uhr
tool (6). In order to remove the mixing tool,
proceed in reverse order.

8. Operation

84.5 dB(A)
8.1 ON/OFF switch (Fig. 3/Item 1)
3 dB
First fit a suitable mixing tool (6) to the
95.5 dB(A)
appliance (see 7).
Connect the mains plug to a suitable
3 dB
socket.
To switch on:
Press the ON/OFF switch (1)
To switch off:
Release the ON/OFF switch (1)
Switching on continuous operation:
Secure the ON/OFF switch (1) with the locking
button (2).
= 2.92 m/s 2
h
Switching off continuous operation:
Press the ON/OFF switch (1) briefly.
8.2 Adjusting the speed (Fig. 4/Item 3)
Use the speed control (3) to pre-select the
speed.

9. Replacing the power cable

If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
Seite 10