Setting Up The Device - Conrad mccrypt dj-50 Bedienungsanleitung

(25) Low-voltage connection jack "AC9V 500mA"
The low-voltage plug of the supplied plug-in power unit is connected to this jack.
(26) Plug-in power unit
The plug-in power unit is used to supply the mixer with power.

Setting up the device

Make sure when mounting on a desk with other equipment that
there is sufficient ventilation.
Never place the product on soft surfaces such as, for example, a
carpet or a bed. This hinders the heat extraction from the device
and can lead to overheating.
Do not drill or screw any additional screws into the housing of the
mixer to fasten the device. This can damage the device.
When setting up the device, make sure that it has a secure footing
and a stable surface as, if the mixer fell down, persons could be
injured.
When setting up the device, make sure that the connection cable
is not be pinched or damaged by sharp edges.
Always lay the cable so that no-one can stumble over it or get
caught up on it. There is the risk of injury!
When selecting a place to set up the device, make sure that direct
intensive sunlight, vibrations, dust, heat, cold and moisture are
avoided.
No devices with strong electric or magnetic fields may be located
in the vicinity of the mixer as these can influence the mixer.
Such devices are: transformers, motors, cordless telephones,
radios, PCs, etc.
36
Due to the multitude of paints and polishes used for furniture, the base of
the device might leave visible residues on the furniture it is placed on cau-
sed by a chemical reaction. For this reason, the device should not be pla-
ced on valuable furniture surfaces.
The mixer is suitable for installation in a desk and as a table device. For fastening
when mounting in a desk, there are the 4 fastening holes in the upper covering
board.
Connection
Before connection, disconnect the mixer and all other devices
which are to be connected with the mixer from the mains voltage
(pull plug-in power unit or mains plug out of the socket).
For connecting the cinch in and outputs, use only shielded cinch
cables suitable for this purpose. For connecting the microphone
input, please only use suitable microphone cable. The use of oth-
er lines may cause interference.
To avoid distortion or mismatching which may damage the
device, only reproduction devices with a cinch output may be
connected to the cinch inputs of the mixer. Only devices with the
same inputs may be connected to the cinch outputs of the mixer.
For this, observe also the connection values in the section "Tech-
nical Data".
Connection of the inputs
The following applies for all cinch inputs:
The white cinch jack of the mixer is the input for the left channel.
The red cinch jack of the mixer is the input for the right channel.
Inputs LINE1 (21) and LINE2 (23)
Two LINE inputs are available. You can connect your tuner, your CD player, your
MP3 player etc. to these stereo cinch inputs.
The LINE inputs are not suitable for record players.
37