Werbung
The maximum load of any mixer START switch contact is 0.5
Ampere / 24 Volt DC. If this is exceeded, it can lead to damage to
the mixer.
Setting up the device
Make sure when mounting on a desk with other equipment that
there is sufficient ventilation.
Never place the product on soft surfaces such as, for example, a
carpet or a bed. This hinders the heat extraction from the device
and can lead to overheating (risk of fire!).
Do not drill or screw any additional screws into the housing of the
mixer to fasten the device. This can damage the device.
When setting up the device, make sure that it has a secure foot-
ing and a stable surface as, if the mixer fell down, persons could
be injured.
When setting up the device, make sure that the connection cable
is not be pinched or damaged by sharp edges.
Always lay the cable so that no-one can stumble over it or be
caught up in it. There is the risk of injury!
When selecting a place to set up the device, make sure that
direct, intensive sunlight, vibrations, dust, heat, cold and mois-
ture are avoided.
No devices with strong electric or magnetic fields may be located
in the vicinity of the mixer as these can influence the mixer.
Such devices are: transformers, motors, cordless telephones,
radios, PCs, etc.
42
Downloaded from
www.Manualslib.com
manuals search engine
Due to the multitude of paints and polishes used for furniture, it annot
be ruled out that the feet of the device may leave visible residue on the
furniture. For this reason, the device should not be placed on valuable
furniture surfaces without suitable protection.
The mixer is suitable for installation in a desk and as a table device. For fastening
when mounting on a desk, there are the 4 fastening holes in the upper covering
board.
Connection
Before connection, disconnect the mixer and all other devices
which are to be connected to the mixer from the mains voltage
(pull mains plug out of the socket).
For connecting the cinch in and outputs, use only shielded cinch
cables suitable for this purpose. For connecting the microphone
inputs, please only use suitable microphone cable. The use of oth-
er cable may cause interference.
To avoid distortion or mismatching that may damage the device,
only reproduction devices with a cinch output may be connected
to the cinch inputs of the mixer. Only devices with the same inputs
may be connected to the cinch outputs of the mixer.
For this, observe also the connection values in the section "Tech-
nical Data".
Connecting the inputs
The following applies for all cinch inputs:
The white cinch jack of the mixer is the input for the left channel.
The red cinch jack of the mixer is the input for the right channel.
LINE1-6 inputs (33)
Six stereo cinch inputs LINE are available. You can connect your tuner, your CD
player, your MP3 player etc. to these stereo cinch inputs.
The LINE inputs are not suitable for record players.
43
Quicklinks ausblenden:
Werbung
Kapitel
