Inhaltsverzeichnis
Werbung
Connecting
the appliance
After installing the appliance, wait at least
½ hour until the appliance starts up.
During transportation the oil in the com
pressor may have flowed into the refri
geration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to 220-240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 to 16 A fuse or higher.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may be
replaced by an electrician only.
Warning!
!
Never connect the appliance to elec
tronic energy saver plugs or to power
inverters which convert the direct
current to 230 V alternating current
(e.g. solar equipment, power supplies
on ships).
Switching on
the appliance
Fig. 1
Switch on the appliance with On/Off
button 2.
Fig. 2
A warning signal sounds, AL" flashes on
the freezer compartment display.
Press the Warning signal Off" button.
The warning signal switches off.
Display AL" goes out when the appliance
has reached the set temperature.
The factory has recommended and set
the following temperatures:
Refrigerator compartment:
Freezer compartment:
Operating tips
S The fully automatic Nofrost system
keeps the freezer compartment and
refrigerator compartment free of ice.
Defrosting is no required.
S The sides of the housing are sometimes
heated slightly. This prevents conden
sation in the area of the door seal.
S If you cannot open the freezer com
partment door immediately after closing
it, wait 2 3 minutes until the partial
vacuum has equalised.
en
+4 °C
-18 °C
27
Werbung
Inhaltsverzeichnis
