Sony SnapLab UP-CR25L Bedienungsanleitung Seite 27

4
Depending on the width of your paper roll, attach or
remove the paper adapters.
Paper with 127-mm (5-inch) width: 2UPC-R253/
R255 series Printing Pack
Attach the blue paper adapter to the left side of the unit,
and the pink paper adapter to the right side. (The unit is
factory shipped with the paper adapters attached.)
blue
Press the portions indicated by the arrows until the tabs at
the top lock into place.
Paper with 152-mm (6-inch) width: 2UPC-R254/
R256/C560 series Printing Pack
Remove the blue and pink paper adapters.
Note
Store removed paper adapters in a safe place.
5
Load the paper roll.
Be sure to load the paper roll with the arrow on the seal
pointing inside the unit.
Note
To prevent the paper roll from sliding off, hold both
sides of the paper core when loading it into the unit.
pink
6
Remove the seal affixed to the paper roll.
7
Close the paper door, and press the center of the door
until it clicks into place.
To load the ink ribbon
1
Pull the ribbon door toward you to open it.
2
Remove the ribbon tray.
3
Detach the white spool of the ink ribbon from the black
spool.
Loading the Paper Roll and Ink Ribbon
27