Operating And Transport Environmental Conditions; Environmental Disposal Instructions - Faro nicea Serie Gebrauchsanleitung

Crushing of body parts hazard warnings
The equipment has motorised door closure. Only hold the door by the handle, or push it from the
outside.
Be careful of your finger/hand position while closing the door. Do not leave fingers or other body parts
between the door and the machine while it is closing.
Burn hazard warnings
To prevent possible burns, extract the trays with the dedicated pincers provided.
Before cleaning any surface, make sure that it has cooled down.
Infect hazard warnings
The autoclave performs a sterilisation process. However, the user must guarantee the effectiveness
of the sterilisation process by following the guidelines as well as the data provided by the autoclave.
Therefore, strictly follow the protocols defined in this manual to ensure that the process continues to
be effective.
Note
The device, when on, must always have the tray holder and tray on the lower shelf.

1.4 Operating and transport environmental conditions

In its packaging, the equipment can withstand the following environmental conditions for no more that 15 weeks:
Ambient temperature from -20°C to +70°C
Relative humidity from 10% to 90%
Atmospheric pressure from 500 to 1060 mBar.
The appliance must be used in the following environmental conditions:
- internal use
- altitude up to 3000 m
- temperature from 5°C to 40°C
- max relative humidity 85%
- max mains voltage variation ± 10%
- installation category (overvoltage category) II
- pollution degree rating 2
- ambient lighting 500 lx

1.5 Environmental disposal instructions

Pursuant to directives 2012/19 EC and 2011/65 EC on waste electrical and electronic equipment and the restriction of
the use of certain hazardous substances in electrical and electronic equipment, waste cannot be disposed of as urban
waste, but must be collected separately.
When purchasing new equipment of an equivalent type on a one-for-one basis, the equipment that has reached the end
of its life must be returned to the dealer for disposal. Regarding reuse, recycling or the other forms of waste recovery
mentioned above, the manufacturer must carry out the steps defined by the individual national legislation.
Adequate separate collection for future use of the equipment assigned for recycling, treatment and environmentally
friendly disposal helps to prevent possible negative effects on the environment and on human health, and promotes
recycling and/or reuse of the materials that make up the equipment.
The crossed-out bin symbol (see symbols on page 1) on the device or on its packaging indicates that the product must
be disposed of separately from other waste at the end of its life.
43 43