Installing The Appliance; Turning On The Appliance - KKT KOLBE EB8016ED Benutzerhandbuch

Installation and connection of the appliance / Troubleshooting

Installing the appliance

• The stability of the furniture must comply with DIN 68930.
• On the built-in niche no back wall may be present, so that
the ventilation is ensured.
• Push the device all the way into the niche.
• Open the oven door and fasten the left and right with the
supplied four screws and sleeves on the cabinet. Do not
overtighten the screws.

Turning on the appliance

Remove all packaging materials and possibly remove protec-
tive films.
• Clean the oven and the accessories just moist.
• Set the current time to the timer (on some models only).
• Operate the empty oven for about 30 minutes with top
and bottom heat and maximum temperature. The resul-
ting typical smell of a brand is unavoidable. Please ven-
tilate the room.
What to do in case of problems?
Warning - Risk of electric shock!
Incorrect repairs are dangerous!
Repairs and the replacement of a damaged power cable
may only be carried out by a certified electrician.
If the appliance is defective, unplug the appliance from
the mains or switch off the circuit breaker in the fuse box.
Contact a certified electrician or the customer service.
The oven doesn't heat up.
• Has the fuse in the domestic installation been triggered?
• Have the temperature and heating mode been set correctly?
The device fuse keeps blowing.
• Contact the customer service or a licensed electrician.
The Lighting has failed.
• To replace the lighting, see corresponding chapter.
The cooking result is not satisfactory.
• Have the recipe instructions correctly been followed and
have the application guidelines in this manual been folloed?
38
KKT KOLBE customer service
Tel. 0049 9502 667930
Mail: info@kolbe.de
www: www.kolbe.de
→ You can find further data and
documents on our website under
Support-Center.