Safety Advice - Foppapedretti B9/0407113 Montageanweisungen

GB

SAFETY ADVICE

WARNING: Read these instructions carefully before use and keep this manual for future reference.
Failure to comply with these instructions may put your child's safety at risk. This base must only
be used with the Group 0+ infant car seat (type B9) designed for this base.
This base must only be placed in a forward facing position on a car seat provided with a -point
safety belt according to regulation ECE R1 or an equivalent standard (1).
WARNING: DO NOT USE THIS INFANT CAR SEAT ON SEATS EQUIPPED WITH AIRBAGS
Base 0+ (2)
A. Anti-tipping bar
B. Locking mechanism (x)
C. Passage for the lap belt
D. Compartment for the instruction booklet
E. Retainer for the diagonal belt
F. Locking/release handle for travel system infant car seat Group 0+
Fitting the base in the vehicle
Place the Base 0+ on the front passenger seat or on the rear seat of the vehicle so that it is always
positioned with the anti-tipping bar against the backrest of the seat (). Pull and fasten the safety
belt fitted in the vehicle (4).
Insert the lap part of the belt inside the opening that is located in the front part of the base close
to the anti-tipping bar (). Tighten the diagonal belt .
Fitting the infant car seat on the base
Important: Always make sure that the handle of the infant car seat group 0+ is in the vertical
position before securing the infant car seat to the base 0+ ().
Position the infant car seat 0+ so that it faces towards the rear of the vehicle. Line up the locking
mechanisms of the infant car seat with their respective slots on the base, close to the anti-tipping
bar (7). Recline the infant car seat towards the base (8) fastening the backrest of the infant car
seat to the locking/release handle, located on the base (9). A click will indicate that it has been
fastened correctly.
To check it has been fastened correctly, lift the infant car seat using the handle. It should remain
firmly secured to the base.
Pull the diagonal belt and insert it in the red retainer located on the backrest of the Base Group
0+ (10).
Make sure that the diagonal belt and the lap belt are not twisted and tighten them securely (11).
Check that the infant car seat Group 0+ is fastened correctly to the base 0+. When the infant car
seat is lifted using the handle, it must remain firmly attached to the base.
Releasing the infant car seat Group 0+ from the base.
To release the infant car seat from the base, remove the diagonal belt fitted in the vehicle from
the red retainer located on the backrest of the base (1), pull the red release handle located on
8