Safety Instructions - Foppapedretti B9/0407113 Montageanweisungen

GB

SAFETY INSTRUCTIONS

WARNING: Read these instructions carefully before use and keep this guide in case you
need to refer to it in the future. Failure to follow these instructions may affect your
child's safety. To avoid any risk of falling, ensure that the handle of your Group 0+ is
correctly locked and that your child's safety harness is always fastened. Only install your
Group 0+ seat on a forward facing seat fitted with a 3 point safety belt (1).
DO NOT USE THIS CHILD SEAT ON A PASSENGER SEAT FITTED WITH AN AIRBAG.
• Rigid elements and plastic parts of the child restraint device must be positioned and
installed so that they do not, under normal vehicle usage conditions, become jammed
under a moveable seat or in the vehicle door.
• Keep all straps used to attach the restraint device to the vehicle taut, and adjust
the straps used to restrain the child. It is also important that the the straps are not
twisted.
• Replace the device when it has been subjected to violent stresses in anaccident.
• It is dangerous to modify or add to the device in any way without approval of the
competent authority. It is also imperative to follow meticulously the instructions provided
by the manufacturer concerning installation of the child restraint device.
• Keep the seat sheltered from sunlight, so that the child cannot get burned.
• Do not leave children unsupervised while in a child restraint device.
• Make sure that luggage and other objects likely to cause injuries to the occupant of the
seat if impact occurs are firmly secured.
• Do not use the child restraint device without the seat cover.
• Do not replace the seat cover with a cover other than the one recommended by the
manufacturer, as it directly influences the behaviour of the restraint device.
• If you are in any doubt about installation and proper use of your seat, please contact
the manufacturer of the child restraint device.
• Install your child restraint system at the seating positions arranged in the 'Universal'
category in the users' manual, using the primary path of the belt.
• Do not use load-bearing contact points other than those described in the instructions
and marked on the restraint system.
• Always give preference to rear seats, even if the highway code allowsinstallationat
the front.
• Always make sure that the car seatbelt is fastened.
• Always check that there is no food debris or other such matter in the buckle.
• In winter take care not to secure the child in with clothes that are too bulky.
TUO
1